G60-12A 12V Car Lead Acid Battery Charger with Battery Meter
|Output: 13.8V 3.3A
|Charge Process: MCU Control, With Recovery Function
|Charger Indicator: With 20%~100% Battery Fuel Gauge
|Output Protections: Short-circuit, Reverse Polarity
|Safety Approval: CE cUL
|Size: 120 x 67 x 41mm
|Suit for Battery: 12 Volt 4~40Ah Lead-Acid Battery Charger
FX Group is a main member of digital-chargers from AnHuiFengXIn Co., Ltd. It represents today's new technology for lead-acid type battery charging. G60-12A programmed four auto stages (Ud-Im-Uo-Up) charging process, It is designed for all kinds of 12V 7~80Ah lead-acid battery, such as SLA, AGM and Gel battery. Stage "Ud" desulfurating the battery through 18V pulse,When the battery recovered, stage "Im" will give bulk current charging( 3.3A or 2.0A). Then, "Uo" stage is followed, the output voltage is limited on 14.7V; When the battery is nearly full, stage"Up" will turn on duty. At this stage, the battery is charged completely and the charger give some pulse to maintenance the battery.
Further, FxGroup can display the charging process, indicate the battery capacity from 25% to 100% timely. This is helpful for user.
For more safety, FxGroup will inter protection mode when the battery polarity reversed or the output connectors shorted.
Specification for G60-12A
|Back current drain
||Rating 12V, Bulk limited voltage : 14.7V
||Current-ripple:<= 0.13A rms
|Bulk charge current
||3.3A for G60-12A, 2.0A for G60-12AS
||Natural convection. Do not cover the charger.
||Auto 4 stages: Ud-I-Uo-Up
||All types of 12V lead-acid batteries.( SLA, Gel, AGM.)
||7-80Ah for G60-12A, 4~40Ah for G60-12AS
||IP54 (Dust protected, Water splashing resistance)
How to use:
1. Connect the AC cord to the socket, The "power" lamp will light on RED.
2. Connect positive charger clip (red) to positive battery terminal, the black clip to negative. (You can use other dc plugs to connect battery), the "25%~100%" lamps will light on flowing. If the battery polarity reversed or output shorted, all lamps will flashing, please check the setup.
3. Depend on the charged capacity, 25%~100% lamps will lights up solid sequence, until the battery is fully charged. Then you can power off the charger and disconnect the battery or you can charge a new battery if you need.
The table shows the duration of the Bulk stepup to about 80% state of charge.